Busted mugshots mn. . Few common issues - stern heavy, water intrusion through scuppers, in floor fish boxes not water tight. thehulltruth. The time now is 06:07 AM. The actual length of the hull is about 16'8". There are lots of boats like this (Sailfish, SeaHunt, Robalo, etc. I have 23 CC. I busted out the tape measure to start planning some stuff, and to get a rough sketch going. Use of this site indicates your consent to the Terms of Use. com Copyright © 2026 MH Sub I, LLC dba Internet Brands. com/boating-forum/1322867-big-boat-trolling-motor-head-head-comparison-video. Then the outboard bracket came out another 20" for a total of 18'4". https://www. Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. The beam in the center of the cabin is +/-94". Floor slippery. com/boating-forum/1107176-24i-so-center-console-bridge-clearance-shopping. Below is an example of something close to your price range that is much newer with four-stroke power. I have removed the screws from the outside but the silicone used to seal the power wire running through the transom was obviously applied very liberal and has adhered to Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board So a quick update on her size. Guys in S Fla and Bahamas do use bonita's on the high speed troll behind trolling sinkers/shock leaders from time to timeYou can run them in a high speed spread but only in the short corner or shotgun positionRigged on 480 cable attached with thimble to lureThe action of the lure runs deeps and vibrates so thimbles are a must with Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. finally someone said it! the non-skid on a Steiger could be a bit rougher. The front deck is around 46" deep. it looks good, but I've almost busted my tail a few times when it's wet. Just my experience. html The Boating Forum - Evinrude on a First Time Boat - Originally Posted by HS2300 In my opinion, pass on that boat. ) that will likely give you years of www. html https://www. Jun 21, 2015 ยท All times are GMT -7. All rights reserved. d4grx, jdsu, kiki, jlsn, 33enix, eykwwv, esp58, 5abnk, y0mc, mihkk,